what is the safest way to flas my wrt54g

Discussion in 'DD-WRT Firmware' started by Dutch_Master, Jun 28, 2005.

  1. Dutch_Master

    Dutch_Master Network Guru Member

    Once bricked my wrt54g while flashing alchemy from satori. I heard it was because of tftp that couldn't handle the large file.

    OK bought a second one a wrt54g v 2.2 (european) with original firmware 3.03.1 but I have problems with sharing the printer at my wired network. Seems to be that I used in the router way behind a draytek 2200e router.

    Now I read that I better use the dd-wrt firmware to run it in acces point mode.
    But with the bricked one on my mind I am a little anxious to flash.
    What is the best and safest way to flash. TFTP or from the web interface. Direct from the original firmware I use now or intermediate steps (satori).
    which dd-wrt firmware is the safest, most stable and so on.

    I don't want to open my wrt54g again and short circuit and so on. I succeeded a few times but failed once (the last time of course), you know!

    Best regards,
    yes from the Netherlands
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice