Where can I find Guide to installing Shibby's Tomato on Stock Linksys E4200?

Discussion in 'Tomato Firmware' started by Rockstead, Sep 14, 2013.

  1. Rockstead

    Rockstead Reformed Router Member

    I've gone through the Help section here and I couldn't locate the guide and I went through the Shibby release site too and I didn't find anything.

    Can I just install it remotely from my PC like I would any upgrade I would for Linksys Firmwares?

    I just know for DD_WRT it was so picky and I had to do 30-30-30 at specifc times but no instructions were packaged with the release.

  2. M_ars

    M_ars Network Guru Member

    What Hardware Version do you have? V1? Behause V2 is Not supported
  3. Rockstead

    Rockstead Reformed Router Member

  4. tomatosoup

    tomatosoup Networkin' Nut Member

    There's no need for installing DD-WRT before Tomato.
    Just make sure you download the 60k NVRAM-Version (NOT 64k, this will brick your router!), and do an upgrade from stock firmware.
    Did this on my E4200 v1 around one year ago without any problems.
  5. Marcel Tunks

    Marcel Tunks Networkin' Nut Member

    See Tomato FAQ, and my response to your double post.
  6. zorkmta

    zorkmta Network Guru Member

    I have 2 linksys e4200 and only flashed directly from stock firmware, after Then did 30-30-30 clean nvram and all working flawless.

    Enviado desde mi GT-I9505 usando Tapatalk
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice