1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

which image to use for WRT54GL 1.1

Discussion in 'Linksys Official Firmware' started by linksys_user[5968708], Jan 27, 2007.

  1. linksys_user[5968708]

    linksys_user[5968708] LI Guru Member

    Hello, I can't find any information on this. I am using WRT54GL 1.1 with firmware version 4.30.7. I would like to upgrade to 4.30.9. I found the 4.30.9 source code on www.Linksys.com, followed the instructions to compile and it was successful. When the compilation is done it spits out a few images, how do I know what image I need to use? Anyone know the difference and can help please advise, here is a list of images:

    Code:
    total 21M
    -rw------- 1 root root 2.8M 2007-01-25 23:20 code.bin
    -rw------- 1 root root 3.0M 2007-01-25 23:20 def_code.bin
    -rw------- 1 root root 165K 2007-01-25 23:20 default_lang.bin
    -rw-r--r-- 1 root root 164K 2007-01-25 23:20 default_lang.trx
    -rw------- 1 root root 2.8M 2007-01-25 23:20 lcode.bin
    -rw-r--r-- 1 root root 2.8M 2007-01-25 23:20 lcode.trx
    -rw-r--r-- 1 root root 2.9M 2007-01-25 23:20 linux.bin
    -rw-r--r-- 1 root root 2.8M 2007-01-25 23:20 linux.trx
    -rwxrwxr-x 1 root root 1.3K 2006-08-03 02:08 mklang.sh*
    -rw-r--r-- 1 root root 3.0M 2007-01-25 23:20 tmp_lcode.bin
    
     
  2. Disman_ca

    Disman_ca Super Moderator Staff Member Member

    I can't tell you for 100% certainty but code.bin is usually the file that you want to use. If you look around and find the 3rd party firmware howto build from source articles, they usually say the code.bin file is the one to use.
     
  3. linksys_user[5968708]

    linksys_user[5968708] LI Guru Member

    Yes, that sounds right. Thanks for clearing this up.

    Best Regards
     
  4. RydeWitM3

    RydeWitM3 LI Guru Member

    Did you end up using the WRT54GL_4.30.9 firmware? if so, have you noticed it being better or worse then the 4.30.7 firmware?

    Thanks
     

Share This Page