1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Why the power led of WRT54GS(v1.0) is alway blink?

Discussion in 'Tomato Firmware' started by KaneMVP, Oct 30, 2007.

  1. KaneMVP

    KaneMVP Guest

    I flashed lastest tomato from DDWRT yesterday. I found that sometimes the power led of WRT54GS(v1.0) is always blink and system is hung. I had to wait five minutes to power on router again .Then I could use WRT54GS.
    I had to flash DDWRT. Everything is OK.But I like to use Tomato ,How can I resolve it?
     
  2. Low-WRT

    Low-WRT LI Guru Member

    You may have already done this, but if not:

    with power on, hold down reset for 30 sec.
    flash tomato
    after it reboots, hold down reset for 30 sec.

    Should then be all good.
     

Share This Page