1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Windows file sharing, can't see the shares?

Discussion in 'DD-WRT Firmware' started by wootwoot, Dec 4, 2005.

  1. wootwoot

    wootwoot Network Guru Member

    Hello, I recently installed the dd-wrt firmware, moving over from the talisman firmware. The problem I have is that I am unable to view other windows computers going from one wireless client to another. What do I need to do to be able to see my other windows clients, thx.
  2. Couledouce

    Couledouce Network Guru Member

    Try mapping your network drive using the IP address of the target PC.
  3. Marsha

    Marsha Network Guru Member

    Well, I'm sure that may work, but it begs the question of the OP. Does the dd-wrt firmware get in the way of Windows NetBios discovery working or not?
  4. wootwoot

    wootwoot Network Guru Member

    I gave this a shot but I was still not able to find the other computer. I am able to ping the computers from each other but I am still not able to find them under my network places.
  5. RdeLeeuw

    RdeLeeuw Guest

    Hello, I recently installed DD-WRT too, and, while browsing the options I found this in the help of administration>management of the webinterface.

    So I disabled it :) I hope it helps you.
  6. KiCo

    KiCo Guest

    My network browsing Well in WRT54G(dd-wrt V23) Client Bridge MODE
    PC1 <---Wire---> WRT54G ))))((((( WRT54G <----Wirw--->PC2

    PROBLEM APEARING WHEN I TRY TO COPY 100M Mb file .. from PC1 to PC2 , then connection broken recently. I Think that Windows geting time out from link .

    With Surfing I haven`t problem , only little delay at first start of browser.
    dd-wrt V23: Loopback:eek:ff AP Watchdog:eek:n WPA 128bit MAC Filter

    As TIP: PC2 is equiped with Centrino , and when (enable Wireless/DisableLAN) connect dirrectly to AP then Problems disapear and everithing is OK.


Share This Page