I am breaking my head over this one. I am trying to configure a wireless access point using the BEFW11S4. Configuration is as follows: modem --wired--> [WAN] BEFW11S4 router [LAN] --wired--> [LAN] BEFW11S4 access point The BEFW11S4 router has the following settings: DHCP, NAT enabled IP: 18.104.22.168 WPA enabled, SSID=A, channel=1 Wireless access enabled The BEFW11S4 access point as the following settings: DHCP, NAT disabled IP: 192.168.1.2 WPA enabled (same settings as router), SSID=A, channel=11 wireless access enabled Roaming from the router to the AP works fine (that is the laptop can associate with the AP), but wireless clients of the access point cannot "see" the internet, in fact, they cannot even see the router at 192.168.1.1. Wired clients of the AP can see the internet fine. Perhaps this has something to do with routing (dynamic or static). Thanks for all your help.