1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

"Wireless Cable" with tomato

Discussion in 'Tomato Firmware' started by Phoenixxx*, Apr 1, 2008.

  1. Phoenixxx*

    Phoenixxx* Addicted to LI Member

    hi,

    i bought 2 Buffalo WHR-HP-G54 routers to build up a wireless bridge. i switched the switch on the bottomside of both over to BRI and it worked fine for me (like a network cable; i could use every ip-adress (without any gateway) for the devices on both routers and they could communicate).
    how must i configure tomato to get my "network cable" back?

    thanks for your help!
    phoenix
     
  2. HennieM

    HennieM Network Guru Member

    --wired--WHR(client)--wireless--WHR(AP)--wired
    or
    --wired--WHR(WET)--wireless--WHR(WET)--wired

    Make sure the IP addresses of both WHRs are in your local subnet and not used by any other device.
     
  3. Phoenixxx*

    Phoenixxx* Addicted to LI Member

    Thank you!
    WET -> WEB=Wireless Ethernet Bridge ????
    I tried WEB on both routers but it don't work
     

Share This Page