Wireless Ethernet Bridge - Need to channel scan for it to connect after powered off/on

Discussion in 'Tomato Firmware' started by kent_franken, Dec 22, 2008.

  1. kent_franken

    kent_franken Guest

    Linksys WRT54GL
    Tomato 1.23
    WPA Personal (PSK) + TKIP
    Wireless Ethernet Bridge mode

    If I power off & on the Linksys, I can not connect to the wireless network until I connect to the Linksys (via Ethernet / wire) and click the "Scan" button on the basic/network/channel option. Clicking "reboot" does not appear to cause this issue.

    Also, it would be nice to have some info in the logs as to the status of the Wireless Ethernet Bridge (wireless mode, connected, or error - not connected because..., etc).
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice