1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Wireless link between 2 WAG54G

Discussion in 'Other Linksys Equipment' started by HiSpeed, Feb 3, 2005.

  1. HiSpeed

    HiSpeed Network Guru Member

    Hi,

    Is there a way to link two WAG54G with WDS ?
     
  2. Morpheus

    Morpheus Network Guru Member

    Sorry The WAG54G will not support WDS.
     
  3. HiSpeed

    HiSpeed Network Guru Member

    Sorry, I don't understand your reply cause the WDS option exists with the last firmwares !?
     
  4. Morpheus

    Morpheus Network Guru Member

    Oh, Put the MAC Address of the 1st WAG54G in the 2nd WAG54G WDS Page and the MAC Address of the 2nd WAG54G MAC Address in the WDS Setup page of the 1st WAG54G.and in the setup of the 2nd WAG54G Put the Gateway IP Address of the 1st WAG54G

    With any luck this will work
     
  5. HiSpeed

    HiSpeed Network Guru Member

    OK, thanks !
    Are you sure the two WDS are required ? Only one is not sufficient ?

    3 MAC addresses are used into a WAG, which one is to give to WDS ? The Wireless MAC address ?

    Is there someone having succeeded this link ?
     
  6. HiSpeed

    HiSpeed Network Guru Member

    Good, it works ! :D

    I used 1.02.7 firmware to do it.

    The first Wag is plugged on the phone line and the second one uses Wireless to access Internet.
     
  7. HiSpeed

    HiSpeed Network Guru Member

    It works but... sometime I lose the connection !? :roll:

    That looks like the well known wireless issue, don't you think ?

    Curiously, with each Wag working alone, I've never lost the connection ! 8O
     

Share This Page