Wireless Script help

Discussion in 'Tomato Firmware' started by Low-WRT, Jan 5, 2009.

  1. Low-WRT

    Low-WRT LI Guru Member

    What's wrong with my script?
    I'm trying to alter it to work on a Buffalo g125.
    The purpose is to show when a wireless client is connected, by the red "DIAG" turning on. Also, it's supposed to ignore my ethernet bridge.
    Thanks!

    Code:
    while sleep 20; do
    minusbridge=$(wl assoclist | grep -v aa:bb:cc:dd:ee:ff)
    if [ -n "$minusbridge" ] ; then
    LED='gpio enable 7'
    else
    LED='gpio disable 7'
    fi
    done
     
  2. Planiwa

    Planiwa Network Guru Member

    Might try swapping enable/disable; "led diag on" and "led diag off" are more intuitive.
     
  3. Low-WRT

    Low-WRT LI Guru Member

    That did it! Thanks so much for the help!

    Code:
    while sleep 20; do
    minusbridge=$(wl assoclist | grep -v aa:bb:cc:dd:ee:ff)
    if [ -n "$minusbridge" ] ; then
    led diag on
    else
    led diag off
    fi
    done
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice