1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

won't enable Wireless anymore

Discussion in 'HyperWRT Firmware' started by xadox, Feb 22, 2005.

  1. xadox

    xadox Network Guru Member

    after updating to the latest HyperWRT Firmware i can't enalbe Wireless anymore.

    The Switch says it's on but the diod on the router is still of, only if i reset the router to defaults it is on again.

    Is this normal?
  2. Toxic

    Toxic Administrator Staff Member

    default setting is on so what are you trying to do?

    you want wireles on? then reset the router,

    Press reset button for 30 seconds after a firmware upgrade.

    running hyperwrt here and no problem with wireless side at all.
  3. xadox

    xadox Network Guru Member

    1. after reseting the router the wlan lamp is on.
    2. After disabling wlan then the lamp gets of.
    3. Enable wlan again, the lamp stays off, but wlan status is written on?
    4. Resetting again and wlan lamp is on.

    My question is now: do i have to make a reset to reaneble wlan? Or should reenabling work also without a reset.
  4. Toxic

    Toxic Administrator Staff Member

    this is wierd as i cannot confirm your findings with the latest firmware.

    if i disable then enable the light goes off and when i enable te light goeson as normal.

    I haev tested this extensively but i cannot get the wireless to not work..

Share This Page