WPS54G and wireless speed

Discussion in 'Other Linksys Equipment' started by mappoint, Aug 25, 2005.

  1. mappoint

    mappoint Network Guru Member

    My WPS54G always shows a transmission rate of 11 mbit/s on the status page regardless of signal quality. The WPS54G is connected to a WRT54G in G mode (G only). Is there something wrong with my unit or is it firmware bug?

    Can anybody confirm this problem?

    Thanks for any response!

  2. mappoint

    mappoint Network Guru Member

    After playing a little bit more with this device i can say it it seems to be firmware bug:

    When on channel 11 status page reports current Tx rate of 11 Mbit/s. When on channel 1 it reports 1 Mbit/s when on channel 2 it reports 2 Mbit/s and so on.

    Tested with firmware 6046 and 6047 found on this website.

  3. ravn

    ravn Network Guru Member

    Current Channel: 10
    Current Tx Rate: 54 Mbits/s

    With 6049....
  4. howardp6

    howardp6 Network Guru Member

    I have not gotten the WPS54G to work with firmware version 6049 and WPA2. I reset it to factory defaults and upgraded the firmware from version 6047. I could not get the WPA2 using the web client and with the biadmin utility. the WPA2 does not come up. Version 6047 only shows 11 Mbs on channel 11.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice