I received a WAP54G yesterday, and Iâ€™m endeavoring to get it up and running. I decided to go ahead and give it a shot, knowing Linksys is horrible with communication. As it turned out, I was right. This unit does have WPA2 though itâ€™s not mentioned on their site, the box, or in the instructions [see pic below]. [/URL][/IMG] The web interface is seriously lagging, at time taking multiple clicks to respond to saves or tab changes. If I try to set a static address it locks up and is unreachable until I reset to factory defaults. Looking at the firmware, it is version 6050 [see pic below]. To make sure I had the latest I checked Linksys (http://www.linksys.com/servlet/Satellite?c=L_Download_C2&childpagename=US%2FLayout&cid=1115417109974&packedargs=sku%3D1114037289494&pagename=Linksys%2FCommon%2FVisitorWrapper) but they only show up to version 6049! [/URL][/IMG] All joking aside Linksys/Cisco, it is way past time to put some serious boot to some behind. Poor product description/information = Lost Revenue Sincerely, Theli93 P.S. Upgraded from a BEFSX41 to a RVL200 - enjoying my experience thus far (2 weeks).