1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WPS54gU2 will not work wireless.....

Discussion in 'Other Linksys Equipment' started by rozema, Aug 22, 2005.

  1. rozema

    rozema Guest

    Hello everyone,

    My network looks like this:

    - E-Tech ADSL ethernet router (Not wireless)
    -- DHCP
    -- Static IP:

    - EdiMax Wireless AP (802.11b)
    -- AP
    -- Static IP: 10.0.0254
    -- Encryption off (was W128)
    -- Broadcast SIID

    - WPS54gU2
    -- Static IP:

    - Clients Win XP (Dyn IP: -

    My issue: Can not make the WPS wireless.
    Can make it work connected through cables - but if I wanted that, I would have bought a normal cabled PS......

    In wireless mode: can see the WPS on my AP as active but cannot acces the WPS. Cannot ping in wireless mode.
    I want to set it up in infrastructure mode.

    Spent 2 days try to make it work - nothing so far. Anyone?

  2. howardp6

    howardp6 Network Guru Member

    Once you configure the WPS54GU2 re-initialize the print server through the Bi-admin Utility (not initialize to factory setting). Disconnect it from your Ethernet Network and power it down and up. You should be able to connect wirelessly at that point, if you set the SS-ID, channel and encryption properly. The WPS54GU2 like the new WPS54G does not support concurrent wired and wireless connections, so that is why you have to disconnect if from your network and power cycle it. You have to setup your printer drivers to the port created by the install of the printserver driver.

Share This Page