WRT with WAP connected to it

Discussion in 'Cisco/Linksys Wireless Routers' started by bearcatflex, Jan 27, 2005.

  1. bearcatflex

    bearcatflex Network Guru Member

    I know I read this somewhere but I keep finding what to do when you only have two WAP's.

    I want to confirm the following setup. It is to note that it currently works fine, but it seems to me this wasn't the best/proper way.

    I have DSL going into my WRT54G, and a Cat-5 cable running from Port 1 to a WAP54G across the house.

    I made the SSID, Encryption and Channel identical on both wifi boxes. However, I read that you should use different Channels for each.

    Is this true? I have not had any interference so far but then again, I have only been using this setup for a day. I can roam around my home with my laptop which was the whole point. I will monitor my setup but just wondering if anyone else did the same setup and use the same or different Channels, SSIDs, etc..

    Thanks - Jim F.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice