1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRT300N v2 too too slow !!!

Discussion in 'Cisco/Linksys Wireless Routers' started by Majid Bin Sawad, Dec 30, 2006.

  1. Majid Bin Sawad

    Majid Bin Sawad LI Guru Member

    Hi All,,

    I have a problem with Wireless Router (WRT300N v2),, This router connected to ADSL modem and used to share internet and access files on another PC.

    My problem is the wireless connection become too slow when i try to access another PC ( It is connected directry to Wireless Router by cable) to show movies. So i cannot see any movies becouse of that.

    I tried to ping that PC and i saw the time between 300 to 800 ms.


    [​IMG]

    I was used before WRT54G and it was OK with me.


    I already update firmware to the lastest one in linksys.com (2.0.0.17).


    I used WEB secrity with disable SSID..


    Majid


    Many thanks for all
    ,,,
     
  2. Majid Bin Sawad

    Majid Bin Sawad LI Guru Member

    No answers :frown: :frown:
     
  3. cactusfazer

    cactusfazer Network Guru Member

    I was having the same probleme and it was resolved with the new firmware2.00.17. My security was WPA2 AES as it is recommanded by Linksys. Have you doing a factory reset after upgrading the router? If so, try to change the security of wireless.
     
  4. Majid Bin Sawad

    Majid Bin Sawad LI Guru Member

    Thanks my frind, I'll try..
     
  5. Majid Bin Sawad

    Majid Bin Sawad LI Guru Member

    Many thanks cactusfazer , After i restored factory setting, it is became OK..
     
  6. blades78

    blades78 LI Guru Member

    I have the same problem. The Router is too slow. I have also two wmp300n V2 but with iperf the throughput is only 16 Mbps. Have you any answer for me? I have reset the router but it is too slow.
     
  7. blades78

    blades78 LI Guru Member

    300 Mbps under Linux And Windows

    :)i have reached the maximum throughput wit wrt300n v2. my personal configuration is:
    1)wrt300n v2
    2)Wmp300n v2 on windows Xp or Vista o linux
    2)PC with traffic Generator as Iperf or traffic generator that use packet.dll
    When i generate traffic with Pc linked to Ehternet of the Router and receive this traffic with wmp300n the maximun throughput is 97 Mbps.
    I have reached also this thrpughput under Linux.
    You can only use ndiswrapper with original Xp windows Driver. Although when you write in shell iwconfig appears "IEEE 802.11g" the link speed is 300 Mbps (Bit Rate). By iperf i have reached 92 Mbps under linux.
    you can't use Madwifi because doesn't support 802.11n draft but only 802.11a/b/g. Have somone experience with Soekris net4801?
     
  8. blades78

    blades78 LI Guru Member

    Look At the Image

    120 Mbps... Non credo ai miei occhi
     

    Attached Files:

Share This Page