WRT300N won't allow connections

Discussion in 'Cisco/Linksys Wireless Routers' started by LordJefe, Oct 2, 2007.

  1. LordJefe

    LordJefe Guest

    I have a customer for whom I tried to install a WRT300n v1.1 router. Client computers will either not connect at all, or go into a connect/disconnect cycle. Every once in a while, it will stay connected, but only until a reboot. When I do have a connection, if I monitor signal strength, it fluctuates constantly.

    I swapped it out for another wrt300n -- same issues. Swapped it for a wrt300n v1.0 with DD-WRT -- same thing. I'm going to try a WRT54G in there, and see what happens. I was going for the 300n for the extended range, since Linksys disco'd the SRX series, but at this point I'm ot of ideas, except pulling cables.

    Anybody have any thoughts?
     
  2. 5uck3rpunch

    5uck3rpunch LI Guru Member

    Return the 300n & get the 54G - believe me
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice