WRT54G 2.2 : Client/Bridge mode without nat?

Discussion in 'Cisco/Linksys Wireless Routers' started by muchod, Apr 5, 2005.

  1. muchod

    muchod Network Guru Member

    Hi,

    I have a WRT54G v2.2 and need to connect in client/bridge mode to a AP/Gateway. This AP/gateway don't support WDS so I need to use Client/Bridge mode.

    I can't use Satori because it don't support v2.2, isn't it?

    What firmware can I use to configure it in client/bridge mode without using NAT and two subnets to setup this network?

    Thanks in advance.
    Regards,
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice