WRT54G and hyperWRT2.0 : Not working after a failure power

Discussion in 'HyperWRT Firmware' started by jeanpba, Jan 13, 2006.

  1. jeanpba

    jeanpba Network Guru Member

    Hello

    I have a WRT54G V2 where I flashed hyperWRT2.0 to use it
    as an access point to communicate with wifi to another WTR54G
    where is my router.

    It worked well but I had a power failure in my house. and when
    the power came back, I saw this WRT54G V2 didn't work any more,
    the wifi communication where broken. I took a cable and saw
    the wired connection was ok.

    I tried to flash hyperWRT2.1 with tofu 12, it was ok but the problem
    is still the same.

    Do you know why this power failure could damage the WRT54G ?
    the other one is working well...

    Thanks for your help

    Cheers

    Jean-Philippe
     
  2. reopeadres

    reopeadres Network Guru Member

    Turn on your wireless
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice