1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

wrt54g and xbox 360

Discussion in 'Cisco/Linksys Wireless Routers' started by critic, Mar 2, 2008.

  1. critic

    critic LI Guru Member

    i have some problems hooking up xbox 360 to my router.

    here is my setup

    cable modem to stock firmeware linksys router (cant check what router becuse its in between the wall) all that goes in to my WRT54G ver 6 with dd wrt instaled. on port 1 comptuer is hooked up on port 2 xbox is hooked up. the xbox and computer cant get online. if i skip my router and connect to computer or xbox everything works like it should. what setting should i check on my wrt router in order to get some kid of internet.

    please help.
     
  2. Toxic

    Toxic Administrator Staff Member

    have you rebooted your cablemodem when you connected the router? have you setup your WAN type for DHCP on the router?
     
  3. critic

    critic LI Guru Member

    ye cable modem was rebooted many times the first router gets ip with no problem and internet with no problem it gives second router the ip addy of 192.168.0.105. but thats about it no internet. i also change the operating mode under advance routing in setup tab from gateway to router but that did not work as well. and dhcp is on both routers. should i turn it off dhcp on the second router???
     
  4. critic

    critic LI Guru Member

    toxic any more ideas???
     
  5. Toxic

    Toxic Administrator Staff Member

    are you getting any DNS ip from DHCP?
     
  6. critic

    critic LI Guru Member

    in the first router with out the problem second router only has internal ip but no internet ip
     
  7. Toxic

    Toxic Administrator Staff Member

    when you add a new network device against a cablemodem you have to reboot the cablemodem. this is due to the CM looking at the device's MAC address that is attached to it. it then issues one IP address. if you remove the network device from a CM and add a new mac address then the CM will not work. only a reboot or if you can clone the mac address of the working device onto the WRT54G then it may work.

    also reboot in thie order.

    1 CM
    2 Router
    3 any other PC's

    you should then find it will get an IP. failing this either the cables are connected incorrectly or not working.
     
  8. critic

    critic LI Guru Member

    i open the wall and switch routers is all up and running now. any special traffic settings for xbox?
     

Share This Page