WRT54G bridged with BEFW11S4 v4

Discussion in 'Cisco/Linksys Wireless Routers' started by kaepone, Aug 18, 2005.

  1. kaepone

    kaepone Guest

    I'd appreciate any help concerning this topic. I have searched around and found out that yes, I can bridge between the WRT54G and the BEFW11S4 v4. However, I still have some questions.
    1. Can WPA now be used with the latest firmware (1.52) of the BEFW11S4?
    2. Since I'm a cheap, stingy guy and only bought the BEFW11S4 because it was FAR, I would like to know if there is any way to bridge two of them, or any reliable way to bridge between a WAP11 and a BEFW11S4?
    My situation: I'd like to hook up an Xbox to one of the units and send the signal to the upstairs router wirelessly, as it is a hassle to run a patch cable.
    3. In your opinion, should I just give up and go buy a WRT54G? Would this cause problems as I'd then have three routers (the BEFW11S4, the WRT54G, and another Linksys router which is plugged into the cable modem)? Or should I try to find a good deal on the WAP54G? Is it as widely support (ie: third-party firmware) as the WRT54G?

    Thanks for the help!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice