WRT54G -- bridging, fans, downgrading

Discussion in 'Cisco/Linksys Wireless Routers' started by dokaben, Mar 17, 2005.

  1. dokaben

    dokaben Guest

    I'm getting ready to buy a WRT54G to use as a cheap bridge. I'd like to connect a few wired ethernet clients in the basement to my primary wireless router (D-Link DI-524) on the main floor.

    Questions ...

    - From what I've read satori will work for one client, alchemy for multiple clients. Is this correct?

    - Are there any models I should avoid for compatibility reasons?

    - Is it possible to downgrade to the original Linksys firmware?

    - I've read about people installing fans. For basic bridging is this necessary?

    Thanks!
     
  2. t4thfavor

    t4thfavor Network Guru Member

    i believe satori will support multiple clients but im not sure

    you could add a fan but unless your planning on running the unit on a higher power level than stock it really isnt nessicairy

    i have installed a fan into my router because i needed to add a little umph
    to the range...
    but it isnt really nessicairy

    yes you can change back if you dont like it there is also a web based configuration (as well as shell prompt) most only have a shell to deal with
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice