1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRT54G Client mode

Discussion in 'Cisco/Linksys Wireless Routers' started by gedikart0, Aug 28, 2005.

  1. gedikart0

    gedikart0 Network Guru Member

    Hello! Help me Please!

    I've got two WRT54G ap-router. I want to use Client mode, but it doesn't work.

    Main router (Linksys 3.03.9 firmware)
    ******************************
    Local IP = 192.168.1.1
    Subnet Mask = 255.255.255.0
    DHCP server: Disable

    Advenced routing:
    Operated mode = Geteway
    Destination LAN IP = 0.0.0.0, Subnet mask = 0.0.0.0, Default gw: 0.0.0.0, Interface = Lan & Wireless
    Wireless security: Disable

    Client router (Sveasoft Alchemy 1.0)
    ******************************
    Internet Connection Type = Static IP
    Internet IP Address = 192.168.1.2
    Geteway = 192.168.1.1
    Static DNS1 = 192.168.1.1

    Local IP = 192.168.2.2
    Subnet mask = 255.255.255.0
    Geteway = 192.168.2.2
    Local DNS = 192.168.1.1
    DHCP Server = Enable

    Wireless mode = Client.
    SSID, Channel = (same as the main router)
    Firewall: Disable
    Wireless security: Disable

    In administration: All settings are default. (I don't know what have to set).

    I tired these settings, but I couldn't ping the main router from the client router. (My client router's WAN port isn't good: it was killed by the lightning). BUT if I use a Freeman-talisman 1.0.2 fw on it, and it's in Client-Bridged mode, I can ping the main router. But with this freeman-talisman I can connect only one PC to the client router (If I connect 2 PC the Internet stop.)

    So, What I set in alchemy, it doesn't work, and the freeman is only works with one PC.


    Please help me! (I try to client mode since 2 weeks)
     
  2. 4Access

    4Access Network Guru Member

    On the client router try setting the Local Gateway back to 0.0.0.0 from 192.168.2.2

    If that doesn't work post the routing table for both routers (On the Advanced Routing page) as well as which mode the client router is functioning in. (Gateway or Router)
     

Share This Page