1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRT54G. Computers-->router-X->internet.

Discussion in 'Cisco/Linksys Wireless Routers' started by JoeK5142, Aug 19, 2006.

  1. JoeK5142

    JoeK5142 LI Guru Member

    I recently purchased a WRT54G Wireless Router. I went through the setup through the disk that comes with it, and set it to DHCP (since I'm running a cable connection). I have two computers hooked into the router via ethernet cables, and one laptop wirelessly. When I check the connections on all three computers, it says connected, but I have no internet. So the problem lies within the router itself. This is the second time that I've purchased this specific wireless router and the second time I've had problems such as this. If anyone could help me, or at least direct me to a better model, it would be greatly appreciated.
     
  2. Esquire

    Esquire Mesquire Staff Member Member

    The problem may not lie with the router but how your cable modem works (assuming you have one) - it may be MAC Address specific which locks to a particular network adapter. Logon to your router and check your broadband connection. Make sure there is a connection.

    [​IMG]
     
  3. JoeK5142

    JoeK5142 LI Guru Member

    Yeah, I'm using a modem. Here's what I get :

    Firmware Version: v1.00.7, Feb. 16, 2006
    Current Time: Not Available
    MAC Address: XX:XX:XX:XX:XX:XX
    Router Name: WRT54G
    Host Name:
    Domain Name:

    Configuration Type
    Login Type: Automatic Configuration - DHCP
    IP Address: 0.0.0.0
    Subnet Mask: 0.0.0.0
    Default Gateway: 0.0.0.0
    DNS 1:
    DNS 2:
    DNS 3:
    MTU: 1500



    EDIT

    However, could I change it to static IP, then take the IP Address and the 2 DNS servers I get in command prompt with ipconfig /all and input them into the static IP options, would that work?

    EDIT 2

    Tried that, still no connection to the internet. Any ideas?
     
  4. Esquire

    Esquire Mesquire Staff Member Member

    Try set it back to automatic configuration and clone your computer's network adapter MAC Address to your WAN.
     
  5. JoeK5142

    JoeK5142 LI Guru Member

    That worked! Thank you so much, that is just amazing. I was so tired of banging my head against the wall. Thanks for helping me solve my problem.
     
  6. alaalamis

    alaalamis Addicted to LI Member

    how make Security to my linksys i donot make to him and i wanna to make to no one password
     

Share This Page