wrt54g - no connect on demand after powerloss?

Discussion in 'Networking Issues' started by Norfolk, Dec 9, 2004.

  1. Norfolk

    Norfolk Guest

    hi!

    i have an european wrt54g behind an ethernet-dsl-modem, and it is set to connect on demand a pptp-line.

    but the first time after a powerloss, i need to call the status-page and "connect" manually. afterwards, whenever i access the inet and the line is down, the router connects by itself - only the first connection is to be established manually. idle-timeout is set on 30 minutes.

    i had the keep-alive-option before, in that case, the router actually did connect after a powerloss, but my isp disconnects the line every 8-24hours, and the router would not reconnect again in such case. therefore i switched to the connect on demand-option, which seems to run good, except the one necessary manual connect... firmware is original, 2.07.1 iirc.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice