WRT54G SNMP interfaces

Discussion in 'Cisco/Linksys Wireless Routers' started by jca27, Jun 21, 2004.

  1. jca27

    jca27 Guest

    I am using the 2.02.2.1.wfb firmware mainly to do SNMP monitoring. I'm trying to monitor wireless traffic in and out of the router. My SNMP app shows 7 interfaces on the router: lo, gre0, eth0, eth1, vlan0, vlan1, and br0. I only have the WAN port and a wireless PC connecting to this router. There are no devices plugged into the 4 switch ports. However, when I look at the IP octets per interface, 4 of the 7 interfaces (eth0, eth1, vlan1, and br0) are showing significant traffic.

    - Can anyone make sense of this?
    - What interface is designated to the wireless clients?

    thanks
     
  2. Tr0utp0nD

    Tr0utp0nD Network Guru Member

    I think for wireless traffic you should focus on the br0 , which I belive is the bridge between the wireless and lan segments. Vlan1 I belive is the wan traffic. (Should have the wan ip address ifconfig) Not entirerly sure about the ethernets, mabye you can post a ifconfig -a ?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice