WRT54g-tm with only one antenna

Discussion in 'Tomato Firmware' started by QSxx, Jan 9, 2010.

  1. QSxx

    QSxx LI Guru Member

    Okay, a quickie here:

    I'm converting my WRT54g-TM for use with only one omnidir high-gain antenna. But before i do that i need to figure out which connector is reffered to as A and which one is B in Tomato wireless settings so i can set everything up properly...

    I'll be connecting antenna on the right side of WRT (power connector is on the left from this perspective).

    Any ideas? (suggestions are welcome too)
     
  2. Toastman

    Toastman Super Moderator Staff Member Member

    Set the router to use one antenna, then measure strength, remove antenna, see if strength drops. There have been some mentions in the past that different firmware versions have had them swapped over, so this might be the best way.
     
  3. ringer004

    ringer004 LI Guru Member

    Just a coincidence, but I just got done doing some similar testing with a WRT54G-TM.

    From what did, antenna 'A' is the one next to the power connector.
    antenna 'B' is next to the reset button.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice