WRT54G v.3 and dd-wrt v23 SP1 final don't seem to play nicely with roadrunner

Discussion in 'DD-WRT Firmware' started by theanswriz42, Aug 4, 2006.

  1. theanswriz42

    theanswriz42 Network Guru Member

    Hello, I have dd-wrt installed on my linksys router and for some reason when I go through the router, my transfer speeds die down quite a bit to around 15 k/sec on cable. Everything is factory default minus my setting up WEP and I haven't a clue what could cause this. Both wired and wireless have the same speed results. Any advice would be appreciated.

    Cheers
     
  2. theanswriz42

    theanswriz42 Network Guru Member

    Well, I updated to v23 SP2 and it was working fine for a short time and then went back to not doing much :(
     
  3. RTSAnime

    RTSAnime Network Guru Member

    odd. I have 23SP1 on a Gv1 working fine with RR. Trying manually setting MTU to 1500.
     
  4. didolgi

    didolgi LI Guru Member

    on Socal.rr.com - no issues

    I'm running a WRT54GL v.1.1 with v23-sp1 and no issues. I have noticed that if QoS is enabled my transfer rates slow even if i'm only using the line for one thing at a time. I'd assume that has more to do with the QoS overhead on the CPU then any basic problem.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice