WRT54G V 6.0 FM V v1.02.4.001 - bandwidth allocation

Discussion in 'Cisco/Linksys Wireless Routers' started by usmcrreed20, Dec 23, 2007.

  1. usmcrreed20

    usmcrreed20 Guest

    Hello,

    I am having issues with my Linksys WRT54G V 6.0 router, running with FirmWare V 1.02.4.001. The issue is that I am having difficulty, figuring out how to manage the bandwidth allocation to either a specific IP, or to one of the hard wire ports on the back of the router. I know that if I were using anything cisco, and could telnet, or hyperteminal into anything, I can just change it via specific config mode on that interface.

    So I suppose my question, is there any possible way to set a bandwidth limit or set a bandwidth allocation on that specific hardwire port / or ip?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice