WRT54G V1.0 not functional, red diag light steady

Discussion in 'Sveasoft Firmware' started by mrbrett, Feb 9, 2005.

  1. mrbrett

    mrbrett Network Guru Member

    I ran satori V 4.0 on my wrt54g without any problem until I push rules using Firewall Builder. I did reset by holding the reset button 10,20,30 and even 60 seconds without success.

    any help will be appreciate
  2. howardp6

    howardp6 Network Guru Member

    Try powering the router down and hold the reset button in for five seconds , while powering it up.
  3. macsat

    macsat Network Guru Member

    if not...

    If that dosnt work, try to do an update with tftp and official firmware.

    I succeded waking mine up like that.
  4. mrbrett

    mrbrett Network Guru Member

    Last night i try something similar but I did not receive ping reply so I assume that the tftp will not work?

    i will retry it tonight.
  5. Toxic

    Toxic Administrator Staff Member

  6. mrbrett

    mrbrett Network Guru Member

    Thanks my baby is back online since yesterday. As I'm living in Canada the pin that I need to short was 5 and 6.

    Thanks again
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice