1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRT54G V1.0 WDS or client mode bridge

Discussion in 'Cisco/Linksys Wireless Routers' started by Anonymous, Oct 23, 2005.

  1. Anonymous

    Anonymous Guest

    Does anyone know what firmware I can put on a WRT54G V1.0 to bridge it wirelessly to a WRT54GS V3 running Talisman 1.1?
     
  2. 4Access

    4Access Network Guru Member

    Both the stable v22-r2 & the v23 beta of DD-WRT support v1.x hardware.

    v22 supports a routed client mode. (LAN ports must be on a different subnet from the wireless network.)

    v23 supports both a routed client mode & a true bridged client mode. (The LAN ports can be on the same subnet as the wireless network when configured in Client Bridge mode, although it should be noted that a lot of people report that they can't get the true it to work when enabling WPA...)

    Rupan's or Tofu's version of HyperWRT might also support client mode but you'll need to double check that since I don't know for sure...

    Good luck.
     

Share This Page