hello everybody, I have Tomato 1.04 installed on WRT54G v1.1 I have upgraded from HyperWRT Tofu, and did administration, configuration, erase nvram - after upgrade to Tomato I setup everything from scratch, and now my router seems to be dead after a while I use IPP2P and QOS, PPPoE connected to DSL modem how can I find cause of this problem, do I need to paste log from device?
ok, I've found the solution for this problem since I have upgraded from HyperWRT to Tomato (and did nvram reset configuration after) I did setup from scratch on my device it kept freezing every 1-2 hours I did NVRAM reset configuration again, I flashed Tomato 1.04 again, and did NVRAM reset AFTER flashing also, I've setup everything again, from the scratch, and device is now up for 9 hours without freezing or any problems so I would just recommend a few steps for all users: 1. erase all data in NVRAM memory (trough) - under Administration-Configuration 2. flash Tomato firmware 3. erase all data in NVRAM memory (trough) - again 4. now you have a clean device, you can proceed with setup I hope this advice will help somebody. Take care, NM
I also did a full NVRAM erase in Thibor, then flashed and did a full NVRAM erase again. This was recommended to me by the cool dudes here. Never had an issue. You did the right thing!
The reason the second erase after flashing is necessary is because when you do it in the older firmware, while it does erase the NVRAM, it restores THAT firmware's defaults. When you then upgrade to Tomato, the previous firmware's defaults are still in NVRAM, requiring a second erase.