WRT54G v2.2 - Add SES-Button for turning WLAN on&off?

Discussion in 'DD-WRT Firmware' started by noob, Mar 15, 2009.

  1. noob

    noob Addicted to LI Member

    Hi,

    I'm using a Linksys WRT54G v2.2 router with Firmware: DD-WRT v24-sp1 (07/27/08) std.
    And I'm searching for a way to turn on/off the WLAN by pressing a button on the router.
    I found a page which say's that the SES-Button was introduced on v3.0, but you can enable it on v2.0 too by using a firmware-upgrade. (http://wiki.openwrt.org/OpenWrtDocs/Hardware/Linksys/WRT54G, chapter 1.3.6 SES-Button)

    I found the location on the board, and soldered a 2-pin button to the two holes with the smaller distance, because the other two holes are obviously only for that the 4-pin-button has a better hold.
    I hope this thought is correct, because I've compared it to the reset-button.

    Well, then I've changed the settigs in the the service-tab of DD-WRT to "SES-button enabled", an then.... nothing!
    It doesn't work... :frown:
    WLAN is activated, and if I press the button, nothing happens...

    Has anyone of you guys any idea how to get this thing working?
    And if there is no way to add this SES-button, is there a way to use the reset-button for turning the WLAN on and off?

    Hope you can help me,
    noob
     
  2. noob

    noob Addicted to LI Member

    Come on, where are the cracks? :biggrin:
    Please help me guys,

    noob
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice