1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRT54G v2.2 connectivity

Discussion in 'Cisco/Linksys Wireless Routers' started by Rattlehead, Mar 11, 2007.

  1. Rattlehead

    Rattlehead Network Guru Member

    Ok Im doing this remotely so bare with the explenation.
    Remote office is a simple cable modem ----> WRT54G v2.2 ------->single pc \ single mac laptop.
    When the PC or Mac are directly connected to the cable modem they get connected and can browse the internet (only one at a time btw).Now they plug in the router and then connect themselves wireless or wired to the WRT54G,they connect to the router but cant browse the internet.WRT54G is getting a WAN IP address as it should and the remote office is able to log into the router and make config changes, they can also run diagnostics and ping the www from the linksys router. I can also remotely connect to the linksys router and make config changes if needed, I can also from the linksys router ping the PC and the MAC. Now the unit was runnign one of the thibor firmware and since the issue started i downgranded back to the standard linksys firmware,still no luck.....any one have any ideas please
     
  2. Toxic

    Toxic Administrator Staff Member

    The cable modem sees a new mac address when you plug in the WRT54G. and needs either ac cloning or a reboot to allow internet connection to work.

    Easiest option is to rebooting devices in this order.

    Cablemodem. (wait until lights are steady)
    then reboot WRT54G (wait until lights are steady)
    Then reboot pc/laptop.
     
  3. Rattlehead

    Rattlehead Network Guru Member

    have tried that toxic.
    That still doesnt work me thinks! any other suggestions?I tried that again and in the exact same way and still nothing I dont know what the problem could be,Im going to send another pre configed router out there and see what happens
     

Share This Page