1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRT54G v2.2 help requested

Discussion in 'Cisco/Linksys Wireless Routers' started by passerby, Apr 3, 2005.

  1. passerby

    passerby Guest

    I just bought a WRT54G v2.2 (in the EU). The router seems to work fine (wireless currently disabled), except for the following problems:

    1. With the original firmware version 3.0.1.3 (EU) I found that Log on the Status tab doesn't work. It is enabled, but neither the Incoming Log nor the Outgoing Log buttons show any traffic after browsing.

    2. Also, on the Diagnostics tab, I only have the Ping and Traceroute buttons, but no place to enter anything.

    3. In desperation, I upgraded to firmware v3.0.3.6, although it is marked US (not EU). However, problems 1 and 2 still persist

    Is there something I can do about this? Or are these known problems of the Linksys firmware? I'd like to resolve these issues before flashing with 3rd party firmware.

    Thank you.
     
  2. Toxic

    Toxic Administrator Staff Member

    not too sure about the logging options on official firmware though using a 3rd party software like hyperwrt, ddwrt or sveasoft firmware and wallwatcher or linklogger will work fine.

    the only difference in US vs EU firmware are usually the amount of wireless channels available.

    US 1-11

    EU-1-13

    though the 3rd party firmwares have 1-13 or 1-14 featured.
     

Share This Page