WRT54G v3.1 router not routing WLAN<-->WAN ?

Discussion in 'Cisco/Linksys Wireless Routers' started by olieske, Feb 10, 2006.

  1. olieske

    olieske Guest

    Hello everybody!

    Problem: My WLAN-client can't connect to the internet.
    Setup:

    Internet===(DSL)[fritz.box](192.168.178.1)===[switch]=
    ==(192.168.178.2:WAN)[WRT54G](WLAN:192.168.180.1)----(192.168.180.100)[ApplePowerbook]

    (The fritz.box 7050 is a nice DSL/WLAN/VoIP-Router from AVM. A PC and a Apple Desktop connected to the switch via LAN work fine.)

    I can connect the WRT from WAN and WLAN without problems, configure it, apply new firmware etc.
    With the WRTs build-in PING and TRACEROUTE I can connect to everyting by IP or URL so even the DNS (DNS masq deamon on the fritz.box) works fine. So routing in general should be ok?

    But the WLAN-Client can't connect to anything else than the WRT!(I can connect to it using either 192.168.180.1 or 192.168.178.2 !)
    Do I have to enable the routing in any way? Do I need a default access restriction which allows packets to pass from the WLAN to the WAN?

    I installed Tofu13c. With the ssh-console I could go deeper into iptable configuration now, but I'm sure this could be set up properly using the web-interface.

    Any Idea?

    Thanks in advance

    Oliver
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice