WRT54G v5 wireless help

Discussion in 'Cisco/Linksys Wireless Routers' started by Anonymous, Feb 2, 2006.

  1. Anonymous

    Anonymous Guest

    I just bought a BEFCMU10 and WRT54G v5 (I didn't realize you couldn't use 3rd party firmware until after I had ordered it), I am able to connect to the internet via ethernet through the BEFCMU10 (which is how I'm doing it now), but whenever I try to connect throught the WRT54G wirelessly, I can only get to the WRT54G's config page. I can access the BEFCMU10's config page when I'm dierectly connected to it, but not when I have wireless through the WRT54G. The WRT54G and the BEFCMU10 have different ip addresses (192.168.0.1 and 192.168.100.1 respectively), all the wires are connected, and I think everything is set up properly.
    I bought these two to replace a WCG200 which had started to give me problems.
    What should I do?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice