WRT54G v7 Remote Management port 443 and 80

Discussion in 'Cisco/Linksys Wireless Routers' started by moshi16, May 12, 2007.

  1. moshi16

    moshi16 LI Guru Member

    Whenever I change my router's port for remote management to either 80 or 443, an I power off and on my unit, I will no longer be able to access the web GUI whether I do it from my local pcs or from remote computers. I see that this problem used to exist on an older version of WRT54G (v5) and it was fixed. This must be a problem on the v7 units also. I already tried firmware 7.00.1 and 7.00.4.

    :confused:
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice