WRT54G v8 - internal antenna connections

Discussion in 'Cisco/Linksys Wireless Routers' started by mike_ct, Nov 26, 2007.

  1. mike_ct

    mike_ct Guest

    regarding the v8 "hard-wired antenna" models, i took mine apart; what i see are the original socket locations in each back corner labeled ANT1 / ANT2 with nothing soldered over them..

    i also see the 2 wires to go into the antenna shells; they are soldered directly to the board.
    there is also 1 female SMA type connector right next to one of the wires.

    where can i solder my yagi to? clip the wires and go right to them? plug into the SMA connector (which is not connectered to anything) or solder to the old ant1/ant2 points.

    i know its the least-desirable of the wrt54g's; but i can't be the only one that has one and is modding it.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice