WRT54G WDS Dlink 900AP+

Discussion in 'Cisco/Linksys Wireless Routers' started by pearj, Oct 4, 2004.

  1. pearj

    pearj Network Guru Member

    Hi,

    I was just wondering if there is any chance of the WRT54G being a repeater for the Dlink 900AP+. The Dlink 900AP+ can apparantly act as a repeater, but I couldn't make the WRT54G talk to it. Was I not trying hard enough? or is it a lost cause because dlink is using a completely different protocol?

    on the WRT54G I'm using Satori-4.0 v2.07.1.7sv firmware.

    in the WRT I put the mac address of the 900AP+ in the WDS, but in the Wireless status the rssi for the WDS connection was always 0.

    I tried WDS in lazy mode and it made no difference.

    Any ideas (short of buying another WRT54G)?
     
  2. iamhives

    iamhives Guest

    I was trying to do the same thing.... but with no success so far. Currently I have my 'old' bridge still running via my Dlink 614+ which is connected to the WRT54G. Would like to do adirect WDS connect between WRT54G and 900AP+ though

    Seems like the WDS standard is not standard. Par for the course I guess
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice