WRT54G wireless client mode on the same subnet as AP?

Discussion in 'Cisco/Linksys Wireless Routers' started by sporktastic, May 4, 2005.

  1. sporktastic

    sporktastic Guest

    Is this possible:

    DSL <=> WRT54G v3 <---wireless---> WRT54G v1 <=> Wired Clients Only

    I have my XBOX and TiVo connected to the v1 WRT54G with the Alchemy running in client mode and I am able to access the internet or any devices attached to the v3 WRT54G. The problem is that I would like the v1 to be transparent and allow both sets of clients to be on the same subnet. TiVo to Go does not work from the v3 router to the v1 router, but if I wire my laptop to the v1 router it is working fine. I have tried putting the TiVo as the DMZ host and it still will not work. I would rather not use WDS since it is large video files and I do not want to loose the bandwidth, but I would like the WRT54G to do nothing other than route the wired traffic over the Wireless port and offload all DHCP and gateway responsibilites to the v3 router.
    Currently the v3 has the stock linksys firmware.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice