WRT54GL 1.1 wireless ethernet bridge -- not working

Discussion in 'Tomato Firmware' started by ajnabi, Nov 25, 2013.

  1. ajnabi

    ajnabi Addicted to LI Member

    SOLVED: After walking away from it and coming back a few hours later, I noticed a typo in the Shared Key password.

    Specs (qty 2): wrt54gl v1.1 with Tomato Firmware v1.28.1816 installed.

    I am trying to set up a wireless ethernet bridge for the purpose of hooking up my LAN printer to the network, as it has to be placed in an area remote from the wired network.

    I have two wrt54gl v1.1 with Tomato Firmware v1.28.1816 installed. Below are the config parameters that I think are pertinent. Right now I have the bridge router hooked up to a computer via one of the LAN ports and it is not allowing me to access the rest of the LAN. Any help appreciated.

    Router 1 (gateway to WAN) settings:
    Wireless Mode: Access point
    IP: 192.168.0.1
    Subnet Mask: 255.255.0.0
    mode: gateway
    NAT loopback: All
    Enable SYN cookies: checked
    channel: 3
    SSID: wrtlink
    Security: WPA Personal (PSK) + TKIP / AES

    Router 2 (the bridge) settings:
    Wireless Mode: Wireless Ethernet Bridge
    IP: 192.168.0.11
    Subnet Mask: 255.255.0.0
    Static DNS: 192.168.0.1
    mode: gateway
    NAT loopback: Forward Only
    Enable SYN cookies: checked
    channel: 3
    SSID: wrtlink
    Security: WPA Personal AES
     
    Last edited: Nov 26, 2013
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice