1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRT54GL as Cisco VPN IPSec Client?

Discussion in 'Networking Issues' started by EntityPacket, May 2, 2007.

  1. EntityPacket

    EntityPacket LI Guru Member

    I don't know much about my VPN setup at work other than that it uses LDAP for AD logins and I use the Cisco VPN Client 4.0.2 (D) to connect from home.

    In the Cisco client settings I use "group authentication" with IPSec over UDP (NAT /PAT) enabled.

    Basically I want to be able to use my WRT54GL as the VPN client so any computer on my home network is connected to the VPN without using the Cisco client. For the life of me I can not figure out how to configure OpenSwan (using OpenWrt) for this setup. I have a looked at a number of ipsec.conf examples and have not found anything that seems appropriate. Can anyone tell me I am at least headed in the right direction? I intend to find out more about the VPN server configuration.

    I also have a Linksys wireless bridge I was thinking I could use in conjunction with the Cisco client and somehow bridge those connections - if that makes any sense.
  2. ifican

    ifican Network Guru Member

    I don't believe you can authenticate to a cisco device set up for use with its own vpn client with any other program.

Share This Page