WRT54GS/Alchemy 1.0 Power LED

Discussion in 'Sveasoft Firmware' started by Lloyd_a, May 26, 2005.

  1. Lloyd_a

    Lloyd_a Network Guru Member

    I have just upgraded the firmware in my new WRT54GS to Alchemy 1.0, and put it into client mode.

    Can someone please tell me what is going on when the power led is flashing. It seems to do this quite a lot, and sometimes a don't seem to be able to connect to the router immediately via the LAN without sending a significant number of pings first.
     
  2. Lloyd_a

    Lloyd_a Network Guru Member

    To add to this strange behaviour, it would appear that I can only make contact if the WLAN led is on. It is almost as if the router does not always complete its boot sequence. Occasionally it does, the WLAN led comes on, and then I can connect.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice