Wrt54GS and Cisco186, Static IP Assignment

Discussion in 'HyperWRT Firmware' started by rizsher, Nov 26, 2004.

  1. rizsher

    rizsher Network Guru Member

    I have a Cisco ATA 186 connected to a WRT54GS. To allow port forwarding, I'm trying to get the 186 to use a Static IP by disabling DHCP on the ATA. When DHCP is enabled on the ATA186, things work fine, i get a dialtone (though there is aproblem when sum1 calls cos even on picking up, the dialling party still hears the ringing tone, this is on account of the port forwarding, whci break whenever the router is rbeooted and the ATA takes another IP To the one the ports are forwareded to). I get the following lines at the bottom of the status page of the ata:
    Version: v3.1.0 atasip (Build 040211A)
    DHCP Assigned: IP[] Subnet[] Route[]

    I then tried to disable DHCP, and made the following changes in the config:

    DHCP: 0 StaticIP:
    StaticRouter: StaticNetMaks:

    At this, the ATA stops workign completely. I can still access the configuration page by goign to, but the phone connected to the router is completely quiet. Bo dialtone. it is as if the ATA's staitc IP assignment breaks the conneciton.

    Any ideas anyone?

    Rizwan Sher
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice