WRT54GS and WAP11 client/bridge?

Discussion in 'Cisco/Linksys Wireless Routers' started by drluckyspin, May 15, 2005.

  1. drluckyspin

    drluckyspin Guest

    So this may be a moot question, but I wanna pose it anyway. I have a WRT54GS v1.0 and an old WAP11 v1.1. They are running the v3.37.6 and v1.4i.1 firmwares respectively.

    My question is: is there any way to configure these two devices so that the WAP11 can act as a ap client of the WRT? I need to connect two wired networks and was hoping I could use the old WAP11.

    Any hints/pointers greatly appreciated.
     
  2. dlawde

    dlawde Guest

    I too am trying to do the same. I have Satori4.0 on the WRT. Wap is in AP client mode. I have seen the WAP11 grab a DHCP IP address from the WRT network (not the WRT itself FWIW), but I can't seem to pass IP traffic. Does this have to be 2 routed networks? I understood that the wireless and LAN ports were bridged.

    Any ideas?

    Thanks for all help.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice