WRT54GS Autobricking?

Discussion in 'Cisco/Linksys Wireless Routers' started by Mobutu, Jul 2, 2005.

  1. Mobutu

    Mobutu Guest

    I have a WRT54GS (v1.1) that seems to have autobricked itself.

    I installed Alchemy 1.0 on it, a week ago, and everything seemed to have worked fine. But today, after a power-cycle, I cannot get any response from it.

    The power light is flashing. WLAN & DMZ lights are off. If I plug a cable into any of the four switch ports, or the internet port, then the corresponding light turns on, but I can't use dhcp to get an address, nor can I ping 192.168.1.1.

    Pressing the reset switch for 30s (or more) has no effect. Pressing reset upon power-on has no effect.

    Why would the router suddenly do this? It seems rather dodgy to me for it not to be able to cope with a power outage.

    Is there any way I can get it going again, other than opening it up? I'd prefer not to have to void the warranty... it's only a week old.
     
  2. ybbmadysu

    ybbmadysu Network Guru Member

    I did the same thing you just did. and now it is a paper weight. I created a new thred asking for help with JTAG as it seems to be the only recovery method possible now.

    Good luck with yours.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice