WRT54GS - Client mode with WPA not working (Alchemy)

Discussion in 'Sveasoft Firmware' started by brainwave, Jan 2, 2005.

  1. brainwave

    brainwave Guest

    I tried to setup my new WRT54GS router as client. The WPA enabled WLAN is driven by a DLINK DWL-2001 Access Point. I'm using the Alchemy 6.0 rc5a firmware from SVEASOFT. I know that the clients have to be in another subnet, because traffic is routed when using Alchemy in client mode. After reading a few postings I found out that I had to use the WAN parameters to configure the device IP, Gateway etc. of the WLAN interface. Everything works fine without encryption. If I enable WPA and log into the WRT54GS I cannot even ping computers in the network the router should be connected with.
    Peraps you can help me with that problem?

    Sorry, but I don't want to use WDS!!!

    brainwave
     
  2. bluedog

    bluedog Network Guru Member

    Wrong Forum

    I believe you will need to post your question in the sveasoft forum as Alchemy hasn't been released to the public yet.
     
  3. Morpheus

    Morpheus Network Guru Member

    WHY?? WDS Rocks in Alchemy 6 rc5a give it a go or pay sevasoft 20 bucks for the support
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice