WRT54GS - No LAN, no WAN

Discussion in 'Cisco/Linksys Wireless Routers' started by Hiker_42, May 17, 2005.

  1. Hiker_42

    Hiker_42 Network Guru Member

    I have a really odd issue where, after havinng been checking out various firmwres, I now have LAN and WAN problems. I can connect to the router prefectly fine via wireless but if I try and connect with a wired connection, DHCP assigns the IP fine but I can't admin the router (can't even ping it). Ipconfig reveals a correct IP, DNS and Gateway but I can't do anything with it. Same thing if I set a static IP (Windows reports I'm connected properly but I can't even ping the router). As for the WAN port, I set the PPPoE details but when I try and get the router to connect, it can't. As if the WAN port isn't working. When connected via wifi, I can open a PPPoE connection from my computer, so the WAN port isn't dead (i.e. I cna open a connection from my computer but can't get the router to open one). Basically, it's just acting like a wireless switch.

    I'm assuming I have dud nvram settings or something (even after flashing any firmware or resetting to factory defaults)

    Any ideas what migh tbe happening here? I have a V1.1 WRT54GS
     
  2. jagboy

    jagboy Network Guru Member

    is hte power led blinking
     
  3. aaronamd

    aaronamd Network Guru Member

    sounds like you flashed with the wrong version of a firmware.some older versions have a different ethernet controler that takes a different driver than newer ones...
     
  4. Hiker_42

    Hiker_42 Network Guru Member

    The power LED's not blinking. I HAD flashed wifibox at one point but have since flashed the official Linksys, HyperWRT, DD-WRT.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice