WRT54GS v3 with HyperWRT 2.1.b1, bridge with Netgear WGR614

Discussion in 'HyperWRT Firmware' started by hahaha, Sep 25, 2005.

  1. hahaha

    hahaha Network Guru Member

    I'm new here. Please forgive me if my question sounds too stupid to you.

    I just purchased a Pinnacle Showcenter 1000g and would like connect it to my PC. My PC, DSL and Netgear WGR614 is in another room. The Showcenter comes with a 802.11g PC card, but the reception for it is not acceptable. Therefore, I bought a Linksys WRT54GS v3 and flashed it to HyperWRT firmware and thinking using it as a bridge or whatever device to improve the reception.

    My setup:
    Room 1: DSL modem, PC and Netfear WDR614 802.11g wireless router
    Room 2: Linksys WRT54GS v3 and Pinnacle Showcenter. I'll connect the Showcenter with WRT54GS with CAT5 cable, not wireless.

    My question:
    What's the best solutions? I just want to get Showcenter connected to PC wirelessly with the best connection speed (watch video).

    Could you please tell the steps as detail as possible
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice